how to adjust glass shower door hinge

Adjusting the hinges on a glass shower door can help ensure a proper fit and keep the door from leaking. Here are the general steps to follow when adjusting the hinges on a glass shower door:

Start by removing the door from the shower by loosening the screws that hold the door in place. Be careful not to lose any of the screws or other hardware.  

Locate the adjustment screws on the hinges. These are typically located on the side of the hinge that attaches to the shower frame. 

To raise the door, turn the adjustment screw clockwise using a screwdriver. To lower the door, turn the screw counter-clockwise. Make small adjustments at a time and check the fit of the door after each adjustment.

Once you have adjusted the door to the desired height, use a level to check that the door is plumb (vertical) and level (horizontal). If necessary, make further adjustments to ensure that the door is properly aligned.

Once you are satisfied with the adjustments, reattach the door to the shower by tightening the screws.

Check that the door opens and closes smoothly, and that there is no gap or leak between the door and the shower frame.

It's important to read the manufacturer's instructions for your specific shower door, as the instructions may vary depending on the model and brand. It's also a good idea to get a professional to help you if you are not sure about any step.

Fan Shaped Glass to Glass Zinc Alloy Shower Door Hinges